Skip to main content
Version: Development Snapshots

Help - Frequent questions?

A list of common config issues and the solutions?

Motor won't start​

  1. Is ARM mode configured?
    • Please check your Arm Mode has been enabled. See details in the Modes
    • Note!! Arm and Throttle hold need to be on different switches. The FC must see minimum throttle before Arm is enabled; therefore, if Arm activates at the same time as throttle hold is removed, it will fail the minimum check.
    • Check status page for Arming disables
  2. Using a Governor?
    • Does the Motor spool in Governor 'passthrough'. If not this could indicate a pin or timer allocation issue. Also please check your Receiver is connected and has the correct channel order.
    • Does the Motor spool in Governor 'Mode 1'. Please confirm you have either Frequency input or Bi-directional Dshot enabled and functioning. Using the Motor override run the motor at minimum speed and confirm there an RPM signal present
    • Governor mode 'Mode 2'. If the motor is able to spool in the other modes but not Mode 2 it means the Battery Voltage is not available. Please update this in the Power tab.

Servo don't respond​

  1. Are servos visible in the servo Tab?

  2. From the servo override does the servo move?

    • Confirm connection of the servos
    • Confirm servos are powered
    • Check all servos.

  3. Servo moves in override but not

    • Confirm miser has been chosen from the Mixer tab.